Evaporative Emission Control Canister: Service and Repair

Evaporative Emission Canister

Service Repair No - 17.15.13

Removal
1. Remove the spare wheel and tire.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

2. Raise and support the vehicle.
3. Remove the evaporative emissions canister.
^ Remove the 2 bolts.
^ Disconnect the 3 lines.
^ Disconnect the electrical connector.





NOTE: Do not disassemble further if the component is removed for access only.

4. NAS vehicles: Remove the fuel tank leakage detection module.
^ Remove the 3 screws.





Installation
1. NAS vehicles: Install the fuel tank leakage detection module.
^ Install the screws.

2. Install the evaporative emissions canister.
^ Connect the electrical connector.
^ Connect the lines.
^ Tighten the bolts to 23 Nm (17 ft. lbs.).

3. Install the spare wheel and tire.