Selector Shaft Seal

Selector Shaft Seal

Service Repair No - 44.15.34





Special Service Tools
Removal

1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
2. LH selector shaft seal only: Remove the exhaust system.





3. Remove the transmission heat shield.
^ Remove the 4 bolts.





4. Release the selector cable and lever.
^ Remove the nut.
^ Compress the latch and release the cable.





5. CAUTION: Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any open connections to prevent contamination.

Remove the selector shaft seal.
^ Install 307-509-1 to the seal.
^ Install 307-509-2 to 307-509-1 and extract the seal.

Installation





1. Using 307-509-3, install the selector shaft seal.
^ Clean the components.
2. Install the selector cable and bracket.
^ Secure with the clip.
^ Tighten the nut to 12 Nm (9 ft. lbs.).
3. Install the transmission heat shield.
^ Install the bolts.
4. LH selector shaft seal only: Install the exhaust system.