Rear Door Fixed Window Glass

Rear Door Fixed Window Glass

Service Repair No - 76.31.31

Removal

1. Remove the rear door window motor and regulator assembly.
2. Lower the rear door glass to the bottom of the door.
^ Remove the wedge.

3. Remove the rear door frame trim.
^ Release the 2 clips.
^ Carefully release the door trim.

4. Carefully remove the inner waist seal.







5. Release the lining from the glass rear channel.
6. Remove the rear door window fixed glass.
^ Remove the grommet.
^ Loosen the Torx screw, but do not remove it completely at this stage.
^ Pull the lower edge of the glass forward to release it from the door frame.







Installation

1. Install the rear door window fixed glass.
^ Make sure the locating peg on the fixed glass has engaged with the door frame.
^ Tighten the Torx screw to 10 Nm (7 lb.ft).

2. Install the channel lining.
3. Install the inner waist seal.
4. Install the door frame trim.
^ Clean the component mating faces.
^ Remove backing tape from adhesive strip.
^ Secure the clips.

5. NOTE: Wedge the glass in this position.

Raise the rear door glass fully.
^ Engage the door glass with the channel.

6. Install the rear door window motor and regulator assembly.