Side Air Bag Module

Side Air Bag Module

Removal

WARNING:
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

1. Make the SRS system safe.
2. Remove the front seat backrest cover.
3. Remove the front seat backrest pad.
^ Remove the front seat head restraint retaining clips.





NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.

4. Remove the side air bag module.
^ Remove the 2 nuts.
^ Remove the 2 nuts.





Installation
1. Install the side air bag module.
^ Tighten the nuts to 10 Nm (7 ft. lbs.).
^ Attach the wiring harness.

2. Install the front seat backrest pad.
^ Install the front seat head restraint retaining clips.

3. Install the front seat backrest cover.