Front Seat Tilt Motor

Front Seat Tilt Motor

Removal
1 Remove the front seat. For additional information, refer to Front Seat Front Seat




2 Remove the front seat cushion side finisher.
- Remove the 2 Torx screws.
- Release from the 3 clips.




3 Release the front seat control switch.
- Remove the 2 screws.
- Remove the 2 clips.
4 Remove the front seat cushion assembly. For additional information, refer to Front Seat Cushion Front Seat Cushion




5 Remove the front seat tilt motor assembly.
- Remove the 4 Torx bolts.
- Disconnect the 7 electrical connectors.




6
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the seat module bracket.
- Remove the 2 Torx bolts.

Installation
1 Install the seat module bracket.
- Tighten the Torx bolts to 10 Nm (7 lb.ft).
2 Install the front seat tilt motor assembly.
- Tighten the 4 Torx bolts to 10 Nm (7 lb.ft).
- Connect the electrical connectors.
3 Install the front seat cushion assembly. For additional information, refer to Front Seat Cushion Front Seat Cushion
4 Install the front seat cushion side finisher.
- Secure in the clips.
- Tighten the screws.
5 Install the front seat control switch.
- Secure in the clips.
- Tighten the screws.
6 Install the front seat. For additional information, refer to Front Seat Front Seat