Rear Brake Disc

Brake Disc

Removal

WARNING: If installing a new brake disc, install new brake pads.

CAUTION: Brake discs must be renewed in pairs.

NOTE:
If the parking brake shoes or the brake discs have been removed for access to other components then DO NOT carry out the bedding in procedure.

NOTE:
LH illustration shown, RH is similar.

NOTE:
The brake pad wear warning indicator sensor must be replaced each time the brake pads are serviced.
1 Using the Land Rover approved diagnostic system, drive the parking brake to the 'mounting position'.
2
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
3 Remove the rear wheel and tire.




4 Remove the brake caliper and anchor plate.




5
NOTE:
Rotate the rear brake disc to locate the parking brake shoe adjuster.
Release the parking brake shoe adjustment.
- Remove the parking brake shoe adjuster access plugs.
- Rotate the parking brake shoe adjuster.




6 Remove the rear brake disc.
- Remove the Allen screw.

Installation
1 Make sure that the rear brake disc and hub mating surfaces are clean.
2 Install the rear brake disc.
- Tighten the bolt to 35 Nm (26 lb.ft).
3 Install the brake caliper and anchor plate.
- Tighten the bolts to 115 Nm (85 lb.ft).
4 Adjust the parking brake. For additional information, refer to Parking Brake Shoe and Lining Adjustment Parking Brake Shoe And Lining Adjustment
5 Install the rear wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).