Valve Cover RH

Valve Cover RH

Removal
1 Disconnect the battery ground cable. For additional information, refer to Specifications Service and Repair
2 Remove the fuel rail. For additional information, refer to Fuel Rail Service and Repair




3 Position the injector harness aside.
- Release the 2 clips.
- Disconnect the 3 fuel injector electrical connectors.




4
CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
Remove the valve cover.
- Release the wiring harness retaining clip.
- Remove the 2 bolts.
- Remove the 4 studs.
5
NOTE:
Do not disassemble further if the component is removed for access only.
Remove and discard the gasket.




6
NOTE:
Note the fitted position.
Remove the bolts and studs. Remove and discard the seals.

Installation
1 Install the bolts and studs.
- Install the new O-ring seals.
- Install the new gasket.
2 Install the valve cover.
- Clean the component mating faces.
- Evenly and progressively tighten the bolts and studs, in the sequence shown, to 10 Nm (7 lb.ft).
- Secure the electrical harness with the clip.
3 Install the injector harness.
- Secure with the clips.
- Connect the fuel injector electrical connectors.
4 Install the fuel rail. For additional information, refer to Fuel Rail Service and Repair
5 Connect the battery ground cable. For additional information, refer to Specifications Service and Repair