Canister Purge Control Valve: Service and Repair

Evaporative Emission Canister Purge Valve

Removal
1 Disconnect the battery ground cable. For additional information, refer to Specifications Service and Repair
2 Remove the intake manifold casting. For additional information, refer to Intake Manifold Service and Repair
3
NOTE:
Note the fitted position.
Release the purge valve from the mounting bracket.
- Remove the bolt.




4
CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
Remove the purge valve.
- Disconnect the 2 hoses.
- Disconnect the electrical connector.

Installation
1 Connect the purge valve.
- Connect the hoses.
- Connect and secure the electrical connector.
2
NOTE:
Align to the position noted on removal.
Install the purge valve, align the peg and tighten the bolt to 6 Nm (4 lb.ft).
3 Install the intake manifold casting. For additional information, refer to Intake Manifold Service and Repair
4 Connect the battery ground cable. For additional information, refer to Specifications Service and Repair