Rear Side Air Curtain Module

Rear Side Air Curtain Module

Removal

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

NOTE:
If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Service and Repair
2 Make the SRS system safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
3 Remove the headliner. For additional information, refer to Headliner Service and Repair




4 Remove the side air curtain module.
- Disconnect the electrical connector.
- Remove the 5 Torx screws.
- Release the retaining strap.

Installation
1 Install the side air curtain module.
- Tighten the Torx screws to 10 Nm (7 lb.ft).
- Connect the electrical connector.
- Secure the retaining strap.
2 Install the headliner. For additional information, refer to Headliner Service and Repair
3 Connect the battery ground cable. For additional information, refer to Specifications Service and Repair