Side Air Curtain Module
Side Air Curtain Module
Removal
WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
NOTE:
If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1 Make the SRS system safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
2 Remove the headliner. For additional information, refer to Headliner Service and Repair
3 Release the roof opening panel drain tube from the securing clips.
4 Release the tire deflation wiring harness from securing clips.
5 Remove the side air curtain module.
- Remove the 8 screws.
- Remove the 5 Torx screws.
- Disconnect the electrical connector.
Installation
1 Install the side air curtain module.
- Tighten the Torx screws to 10 Nm (7 lb.ft).
- Tighten the screws.
- Connect the electrical connector.
2 Secure the tire deflation wiring harness into the clips.
3 Secure the roof opening panel drain tube into the clips.
4 Install the headliner. For additional information, refer to Headliner Service and Repair