Rear Axle Housing Support Insulator

Rear Axle Housing Support Insulator

Special Service Tools






Remover/Installer long 14mm bolt

502-009/5





Bearing set for 14mm and 16mm bolt, 51203





Receiver cup rear differential rear bush

502-009/1





Remover rear differential rear bush

502-009/2





Installer rear differential rear bush

502-009/3

Removal

NOTE:
Take note of the fitted position of the bush.
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the wheels and tires.
3 Remove the rear differential. For additional information, refer to Axle Assembly Rear Drive Axle/Differential




4
NOTE:
Take note of the fitted position of the bush.
Using the special tools, remove the rear axle housing support insulator.

Installation





1 Using the special tools, install the rear axle housing support insulator.
2 Install the rear differential. For additional information, refer to Axle Assembly Rear Drive Axle/Differential
3 Install the wheels and tires.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).