Front Seat Cushion Heater And Blower Assembly

Front Seat Cushion Heater and Blower Assembly

Removal

WARNING: Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.

WARNING: Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.

WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.

WARNING: The correct procedures must always be used when working on SRS components.

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

WARNING: Take extra care when handling SRS components.
1 Disconnect the battery ground cable. For additional information, refer to Procedures
2 Make the air bag supplemental restraint system (SRS) safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
3 Remove the front seat cushion and front seat cushion cover from the front seat base. For additional information, refer to Front Seat Cushion Cover Front Seat Cushion Cover




4 Reposition the front seat base wiring harness trim panel.
- Reposition the front seat for access.
- Remove the 4 screws.




5 Remove the front seat cushion heater and blower motor assembly duct.
- Remove the screw.




6 Remove the 3 screws from the front seat heater and blower motor assembly.




7 Remove the front seat cushion heater and blower motor assembly.
- Disconnect the front seat cushion heater and blower motor assembly electrical connector.

Installation
1 Install the front seat cushion heater and blower motor assembly.
- Connect the front seat cushion heater and blower motor assembly electrical connector.
2 Install the 3 screws to the front seat cushion heater and blower motor assembly.
3 Install the front seat cushion heater and blower motor assembly duct.
- Install the screw.
4 Reposition the front seat base wiring harness trim panel.
- Reposition the front seat for access.
- Install the 4 screws.
5 Install the front seat cushion and cover to the front seat base. For additional information, refer to Front Seat Cushion Cover Front Seat Cushion Cover
6 Connect the battery ground cable. For additional information, refer to Procedures