Tire Pressure Monitoring System Rear Antenna

Tire Pressure Monitoring System Rear Antenna

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the rear wheel and tire.




3 Remove the tire pressure antenna.
- Disconnect the electrical connector.
- Remove the 2 retainers.

Installation
1 To install, reverse the removal procedure.
2 Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
3 Initiate a new tire pressure antenna using T4.