Front Outer Parking Aid Sensor

Front Outer Parking Aid Sensor

Removal





1 Remove the front bumper extension panel screw.
2 Release the front lower edge of the fender splash shield for access.




3
CAUTION: Make sure damage does not occur to bumper cover. Failure to follow this instruction may result in damage to the vehicle.
NOTE:
Access to the parking aid sensor is gained from the rear of the bumper cover.
Remove the front outer parking aid sensor.
- Disconnect the electrical connector.
4 Remove the parking aid sensor trim panel.

Installation
1 Install the parking aid sensor trim panel.
2
CAUTION: Make sure damage does not occur to bumper cover. Failure to follow this instruction may result in damage to the vehicle.
Install the front outer parking aid sensor.
- Connect the electrical connector.
3 Install the front LH fender splash shield.
- Install the screw.