Yaw Rate Sensor: Service and Repair

Yaw Rate Sensor

Removal
1 Disconnect the battery ground cable. For additional information, refer to Procedures
2 Remove the floor console. For additional information, refer to Floor Console Floor Console




3 Remove the yaw rate sensor.
- Disconnect the electrical connector.
- Remove the 2 bolts.

Installation
1 Install the yaw rate sensor.
- Install the 2 bolts and tighten to 7 Nm (5 lb.ft).
- Connect the electrical connector.
2 Install the floor console assembly. For additional information, refer to Floor Console Floor Console
3 Connect the battery ground cable. For additional information, refer to Procedures
4 Using the Land Rover approved diagnostic system, calibrate a new yaw rate sensor.