Selector Shaft Seal

Selector Shaft Seal

Special Service Tools






Seal extractor

307-509-1(LRT-44-033/1)





Seal extractor

307-509-2(LRT-44-033/2)





Seal installer

307-509-3(LRT-44-033/3)

Removal

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.




2 Remove the transmission heat shield.




3 RH side only: Release the selector cable and lever.
- Remove the 2 bolts.
- Remove the nut.




4
CAUTION: Before the disconnection or removal of any components, make sure the area around joint faces and connections are clean. Plug any open connections to prevent contamination.
Remove the selector shaft seal.
- Install 307-509-1 to the seal.
- Install 307-509-2 to 307-509-1 and extract the seal.

Installation





1 Using 307-509-3, install the selector shaft seal.
- Clean the components.
2 RH side only: Install the selector cable and lever.
- Tighten the nut to 12 Nm (9 lb.ft).
- Tighten the bolts to 10 Nm (7 lb.ft).
3 Carry out a transmission fluid level check. For additional information, refer to Transmission Fluid Level Check Transmission Fluid Level Check
4 Install the transmission heat shield.
- Tighten the 3 bolts to 9 Nm (7 ft.lb).