Rear Parking Aid Camera Wiring Harness

Rear Parking Aid Camera Wiring Harness

Removal

CAUTION: Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
1 Remove the LH D-pillar trim panel. For additional information, refer to D-Pillar Trim Panel D-Pillar Trim Panel




2 Remove the rear headliner trim panel.
- Release the 7 clips.
- Disconnect the electrical connector.




3 Disconnect the electrical connector.
4 Remove the LH front seat. For additional information, refer to Front Seat Front Seat
5 Remove the LH scuff plate trim panel. For additional information, refer to Scuff Plate Trim Panel Service and Repair




6 Release the wiring harness cover.
- Release the 3 clips.




7 Disconnect the electrical connector.

Installation





1
CAUTION: Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
Install the camera overlay wiring harness
2 Feed the camera overlay wiring harness along the main wiring harness to the parking aid camera module.
3
CAUTION: Make sure that excessive force is not used when installing the tie straps to the wiring harness. Failure to follow this instruction may result in damage to the harness.
Using suitable tie straps, secure the camera overlay wiring harness to the main body wiring harness.




4 Connect the electrical connector.
5 Install the LH D-pillar upper trim panel. For additional information, refer to D-Pillar Trim Panel D-Pillar Trim Panel




6 Install the rear headliner trim panel.
- Connect the electrical connector.
- Secure the 7 clips.




7 Connect the electrical connector.




8 Secure the wiring harness cover.
- Secure the 3 clips.
9 Install the LH scuff plate trim panel. For additional information, refer to Scuff Plate Trim Panel Service and Repair

10 Install the LH front seat. For additional information, refer to Front Seat Front Seat