Description and Diagnostic Procedure

SYSTEM: Injector Circuit

CIRCUIT DESCRIPTION
The injectors are located in the intake manifold. They inject fuel into the cylinders based on the signals from the Engine Control Module.





DIAGNOSTIC PROCEDURE

1. Check voltage between terminals #10 through 60 of Engine Control Module and body ground.
- If OK proceed to step 3.
- If not OK roceed to step 2.
2. Check AM2 and INJ fuses.
- If OK check for open in harness and connector between ECM and battery.
- If not OK check for short in all the harness and components connected to AM2 and INJ fuses.
3. Check continuity between terminals E01, E02 and body ground.
- If OK proceed to step 4.
- If not OK repair or replace harness or connector.
4. Check operation for Injectors.
- If OK check and replace Engine Control Module.
- If not OK replace Injector.