Fuel Pressure Pulsation Damper: Service and Repair

PROCEDURE

CAUTION: After affecting any repair that requires disassembly of fuel related components, inspect carefully for fuel leaks upon completion.





Removal

1. Disconnect the negative (-) terminal cable from the battery.

CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.

2. Remove the Starter Assembly.
3. Remove the Pulsation Damper and upper gasket.
4. Disconnect the fuel inlet pipe from the fuel pipe support and remove the lower gasket.

Installation

1. Install the fuel inlet pipe and Pulsation Damper with 2 new gaskets.





Note: There are two different sizes of gaskets. The upper gasket (large) and lower gasket (small).

Torque: 41 Nm (30 ft lb)

2. Install the Starter Assembly.
3. Connect the negative (-) terminal cable to the battery.
4. Start the engine and check for fuel leaks.