Connect Engine and Transmission

1. Install transmission to engine. Refer to Transmission and Drivetrain.
2. Connect engine wire.
(a) Connect these parts:
(1) O/D direct clutch speed sensor connector.
(2) No. 1 VSS connector for speedometer.
(3) No. 2 VSS connector for ECM.
(4) PNP switch connector.
(5) Solenoid connector.
(b) Install the 5 wire clamps to the brackets on the transmission.
3. Install oil cooler pipe for transmission.
(a) Temporarily install the oil cooler pipe with the 2 pipe brackets and 2 bolts.
(b) Connect the 2 oil cooler pipes to the unions on the transmission and torque to 34 Nm (25 ft. lbs.).
(c) Tighten the 2 pipe clamp bolts.





4. Install the oil dipstick guide and dipstick for transmission.
(a) Install a new O-ring to the dipstick guide
(b) Apply soapy water to the O-ring.
(c) Connect the dipstick guide end to the dipstick tube of the oil pan.
(d) Install the dipstick guide with the bolt.
(e) Install the dipstick.