Separate Engine and Transmission

1. Remove oil dipstick guide and dipstick for transmission.
(a) Remove the bolt.
(b) Pull out the dipstick guide and dipstick from the port of transmission.
(c) Remove the O-ring from the dipstick guide.





2. Remove oil cooler pipes for transmission.
(a) Remove the 2 bolts.
(b) Loosen the 2 union nuts, and remove the oil cooler pipes.





3. Refer to the illustration.
(a) Disconnect these engine wire connectors:
(1) O/D direct clutch speed sensor connector
(2) No. 1 VSS connector for speedometer
(3) No. 2 VSS connector for ECM
(4) PNP switch connector
(5) Solenoid connector
(b) Disconnect the 5 wire clamps from the brackets on transmission.
4. Remove transmission