No.1 Vehicle Speed Sensor

REPLACEMENT





1. Remove transmission control rod rear side. Remove the transmission control rod rear side set nut.





2. Disconnect No.1 vehicle speed sensor connector.
3. Remove No.1 vehicle speed sensor assembly, as follows:
a. Remove the bolt and No.1 vehicle speed sensor assembly.





b. Remove the speedometer driven gear from No.1 vehicle speed sensor.
c. Remove the O-ring from the No.1 vehicle speed sensor.
4. Install No.1 vehicle speed sensor assembly, as follows:
a. Coat a new O-ring with Automatic Transmission Fluid (ATF) and install it to the speed sensor.
b. Install the speedometer driven gear to the speed sensor.
c. Install the No.1 vehicle speed sensor assembly and torque the bolt.
Torque: 16 Nm (12 ft. lbs.).
5. Connect No.1 vehicle speed sensor connector.
6. Install transmission control rod rear side.
7. Inspect and adjust shift lever position.
a. Loosen the nut on the shift lever.
b. Push the control shaft fully rearward.
c. Return the control shaft lever 2 notches to the N position.
d. Set the shift lever to the N position.
e. While holding the shift lever lightly toward the R position side, tighten the shift lever nut.
Torque: 13 Nm (9 ft. lbs.)
f. Start the engine and make sure that the vehicle moves forward when shifting the lever from the N to D position and reverse when shifting it to the R position.