Brake Pedal Height

CHECK PEDAL HEIGHT
Pedal height from asphalt sheet: 150.0 - 160.0 mm (5.906 - 6.299 inch)
IF NECESSARY, ADJUST PEDAL HEIGHT
a. Remove the No. 1 under cover, end pad, No. 1 safety pad and No. 7 heater to register duct.
b. Disconnect the connector from the stop light switch.
c. Loosen the stop light switch lock nut and remove the stop light switch.
d. Loosen the push rod lock nut.
e. Adjust the pedal height by turning the pedal push rod.
f. Tighten the push rod lock nut.
Torque: 25 Nm (260 kgf-cm, 19 ft. lbs.)
g. Install the stop light switch.
h. Push in the brake pedal 5 - 15 mm (0.20 - 0.59 inch), turn the stop light switch to lock the nut in the position where the stop light goes off.
i. Connect the connector to the stop light switch. After installation, push in the brake pedal 5 - 15 mm (0.20 - 0.59 inch), check that stop light lights up.
k. After adjusting the pedal height, check the pedal freeplay.
l. Install the No. 7 heater to register duct, No. 1 safety pad, end pad and No. 1 under cover.