Removal and Installation

REMOVAL
1. REMOVE NO. 1 UNDER COVER AND NO. 1 SAFETY PAD
2. REMOVE PARKING BRAKE PEDAL ASSEMBLY
a) Disconnect the parking brake switch connector.
b) Remove the 2 bolts, and disconnect the parking brake release cable sub-assembly from the safety pad.
Torque: 6.0 Nm (61 kgf-cm, 53 inch lbs.)
c) Remove the lock nut and the adjusting nut from the parking brake wire.
Torque: 6.0 Nm (61 kgf-cm, 53 inch lbs.)
d) Remove the parking brake wire.
e) Remove the 3 nuts and parking brake pedal assembly.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)

INSTALLATION
Installation is in the reverse order of removal.

HINT: After the installation, check and adjust parking brake pedal travel.