Diesel Data: Automotive Repair

Canada - A/C - Flutter Noise, A/C Vents






Bulletin
0581

Issue Date
2003-04-02

Market
Canada

Reference
HA-02-001

Model
LS430

Year Range
2001

Component
HA

Subject:
FLUTTER SOUND FROM HVAC VENT


Some 2001 model year LS430 owners may experience a flutter sound from the center A/C vents. To correct this concern, a new heater case sub-assembly has been made available for dealer installation.

APPLICABLE VEHICLES: 2001 model year LS 430 vehicles produced before the VIN shown below.







PRODUCTION CHANGE INFORMATION:







PARTS INFORMATION:

REPAIR PROCEDURE:







Replacement of Heater Case Sub-Assembly







1. Remove Instrument Safety Pad
Remove the instrument safety pad as explained the 2002 LS430 Repair Manual Volume 2 (Pub. No. RM874U2).







2. Remove Air Duct Sub-Assembly
a) Remove the 5 Philips Head screws.







b) Using a flat tip screwdriver, release the 2 retaining tabs at the top of the air duct.

NOTE:
Be careful not to break the retaining tabs, as this part will be reused.








c) Remove the air duct sub-assembly.

HINT:
After removing the retaining screws, pull outward on the top of the duct.








NOTE:
- Be careful not to touch or move the pulley and wire of the heater unit sub-assembly.
- If these parts get separated or moved, the reinstallation may be impossible and the HVAC unit assembly replacement will be necessary.








3. Remove Bracket
a) Remove the 3 screws holding the heater case and bracket.
b) Remove the bolt and grommet by the side of the body and bracket.

NOTE:
- Be careful not to apply pressure to the step motor of the heater unit sub-assembly during removal.
- Do not remove the step motor at this time.








4. Remove Heater Case Sub-Assembly
a) Using a flat tip screwdriver, release the retaining tabs from both sides on the heater case.

NOTE:
Be careful not to damage the retaining tabs on the side of the heater unit sub-assembly as shown in illustration.








b) Remove the 5 screws.
c) Remove the heater case sub-assembly.







NOTE:
- Be careful not to touch or move the pulley and wire of the heater unit sub-assembly.
- If these parts get separated or moved, the reinstallation may be impossible and the HVAC unit assembly replacement will be necessary.








5. Install New Heater Case Sub-Assembly

NOTE:
Do not touch the sliding surface of the film door and heater case sub-assembly.








NOTE:
Be careful not to transfer any oil or dust to the sliding surface of the film door or heater case sub-assembly.








a) Install the new heater case sub-assembly, then confirm that the heater case sub-assembly is correctly placed to the heater unit at the 2 retaining tabs.
b) Fasten the heater case sub-assembly to the heater unit with the 5 screws.







6. Install Bracket
a) Install the bracket to the heater case with the 3 screws.
b) Install the bolt and grommet.

NOTE:
Be careful not to apply pressure to the step motor of the heater unit sub-assembly.








7. Install Air Duct Sub-Assembly
a) Confirm that the 2 retaining tabs are firmly installed.
b) Install the air duct sub-assembly to the heater unit with 5 screws.

NOTE:
Be careful not to apply pressure to the pulley and cable of the heater unit sub-assembly.


8. Install Instrument Safety Pad
Install the instrument safety pad as explained the 2002 LS430 Repair Manual Volume 2 (Pub. No. RM874U2).







REPAIR TIME:


NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.