Parking Brake Pedal: Service and Repair

REMOVAL
1. REMOVE NO. 1 UNDER COVER AND NO. 1 SAFETY PAD
2. REMOVE PARKING BRAKE PEDAL ASSEMBLY
a. Disconnect the parking brake switch connector.
b. Remove the 2 bolts, and disconnect the parking brake release cable sub-assembly from the safety pad.
Torque: 6.0 Nm (61 kgf-cm, 53 inch lbs.)
c. Remove the lock nut and the adjusting nut from the parking brake wire.
Torque: 6.0 Nm (61 kgf-cm, 53 inch lbs.)
d. Remove the parking brake wire.
e. Remove the 3 nuts and parking brake pedal assembly.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)

DISASSEMBLY
1. REMOVE PARKING BRAKE RELEASE CABLE
2. REMOVE PARKING BRAKE SWITCH
Remove the screw and parking brake switch from the parking brake control pedal assembly.
3. REMOVE PEDAL RETURN ABSORBER
Remove the 2 E-rings, pedal return absorber and bush.
4. REMOVE PEDAL PAD

REASSEMBLY
Reassembly is to be done in the reverse order of disassembly.

INSTALLATION
Installation is in the reverse order of removal.

HINT: After the installation, check and adjust parking brake pedal travel.