Drive Belt: Service and Repair

DRIVE BELT

Components:

REMOVAL
1. REMOVE COOL AIR INTAKE DUCT SEAL
2. REMOVE NO.1 AIR CLEANER INLET





3. REMOVE FAN AND GENERATOR V-BELT
a. Loosen the belt tension by turning the belt tensioner counterclockwise, and remove the belt.

HINT: The tension pulley has a left hand thread.

INSTALLATION





1. INSTALL FAN AND GENERATOR V-BELT
a. Set the V-belt to everything except the idler pulley No.2, as shown in the illustration.
b. Loosen the V-belt by turning the belt tensioner counterclockwise.
c. Then set the V-belt to the idler pulley.





d. After a new belt has been installed, check that the mark is within the A range shown in the illustration.

2. INSTALL NO.1 AIR CLEANER INLET
3. INSTALL COOL AIR INTAKE DUCT SEAL