Installation

STEERING COLUMN: STEERING COLUMN ASSEMBLY:

INSTALLATION

1. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY

(a) Align the matchmarks on the steering intermediate shaft assembly and the steering main shaft.
(b) Install the bolt.
Torque: 35 Nm (360 kgf-cm, 26 ft-lbf)
2. INSTALL STEERING COLUMN ASSEMBLY

(a) Install the steering column assembly with the bolt and 2 nuts.
Torque: 21 Nm (214 kgf-cm, 16 ft-lbf)
(b) Connect the connectors and wire harness clamps to the steering column assembly.

(a) Align the matchmarks on the steering intermediate shaft assembly and the power steering link assembly.

(b) Install the bolt.
Torque: 35 Nm (360 kgf-cm, 26 ft-lbf)
4. INSTALL FRONT WHEEL LH
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
5. INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY

(a) Engage the 2 claws to install the No. 1 air duct sub-assembly.
6. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
7. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

(a) Install the turn signal switch assembly with spiral cable sub-assembly to the steering column assembly with the clamp.
(b) Connect the connectors to the turn signal switch assembly with spiral cable sub-assembly.
8. INSTALL TILT AND TELESCOPIC SWITCH

(a) Engage the claw to install the tilt and telescopic switch.
(b) Connect the connector.
9. INSTALL STEERING COLUMN COVER

(a) Engage the claw to install the upper steering column cover.

(b) Engage the 2 claws to install the lower steering column cover.
NOTE: Do not damage the tilt and telescopic switch.

(c) Install the 2 screws.
Torque: 2.0 Nm (20 kgf-cm, 18 in-lbf)
10. ADJUST SPIRAL CABLE

11. INSTALL STEERING WHEEL ASSEMBLY

(a) Align the matchmarks on the steering wheel assembly and steering main shaft assembly.
(b) Install the steering wheel assembly set nut.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
12. INSPECT STEERING WHEEL CENTER POINT
13. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

14. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

15. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

16. INSTALL SIDE INSTRUMENT PANEL LH

17. INSTALL FRONT DOOR OPENING TRIM COVER LH

18. INSTALL FRONT DOOR SCUFF PLATE LH

19. INSTALL STEERING PAD

20. INSTALL NO. 3 LOWER STEERING WHEEL COVER

21. INSTALL NO. 2 LOWER STEERING WHEEL COVER

22. INSPECT STEERING PAD

23. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
- Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter Power Tilt and Power Telescopic Steering Column System.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

24. INSPECT SRS WARNING LIGHT
HINT: