Clock: Service and Repair

Clock:

CLOCK

REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH
5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
6. REMOVE NO.3 BOX PANEL
7. REMOVE REAR CONSOLE PANEL UPPER
8. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER
9. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
10. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY WITH BRACKET (w/o Multi-display)
11. REMOVE DISPLAY AND NAVIGATION ASSEMBLY WITH BRACKET (w/ Multi-display)

12. REMOVE CLOCK ASSEMBLY
a. Using a screwdriver, detach the 2 claws and remove the clock.

HINT: Tape the screwdriver tip before use.

INSTALLATION

1. INSTALL CLOCK ASSEMBLY
a. Attach the 2 claws to install the clock.

2. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY WITH BRACKET (w/o Multi-display)
3. INSTALL DISPLAY AND NAVIGATION ASSEMBLY WITH BRACKET (w/Multi-display)
4. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET
5. INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER
6. INSTALL REAR CONSOLE PANEL UPPER
7. INSTALL NO.3 BOX PANEL
8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
9. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
10. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. INSTALL COWL TOP VENTILATOR LOUVER RH

13. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.