Height Control Valve (For Rear Side)
REMOVALCAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing.
1. REMOVE COWL TOP VENTILATOR LOUVER RH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
3. REMOVE REAR WHEEL RH
4. REMOVE QUARTER PANEL WHEEL OPENING MOULDING RH
a. Remove the 4 screws and moulding.
5. REMOVE REAR WHEEL HOUSE RH LINER
a. Remove the 2 clips and 3 screws.
b. Remove the 11 nuts and rear wheel house liner.
6. REMOVE NO. 2 HEIGHT CONTROL VALVE SUB-ASSEMBLY
a. Disconnect the connector.
b. Using SST, disconnect the 3 air tubes.
SST 09730-00010
c. Disconnect the air tube from the clamp.
d. Remove the 2 nuts and height control valve.
INSTALLATION
1. INSTALL NO. 2 HEIGHT CONTROL VALVE SUBASSEMBLY
a. Install the height control valve with the 2 nuts.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
b. Connect the air tube to the clamp.
c. Connect the 3 air tubes.
d. Connect the connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. INSTALL COWL TOP VENTILATOR LOUVER RH
4. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
5. CHECK SRS WARNING LIGHT
a. Check the SRS warning light.
6. INSPECT FOR AIR LEAK
a. Inspect for air leak.
7. INSTALL REAR WHEEL HOUSE RH LINER
a. Install the rear fender liner with the 11 nuts.
b. Install the 2 clips and 3 screws.
8. INSTALL QUARTER PANEL WHEEL OPENING MOULDING RH
a. Install the moulding with the 4 screws.
9. INSTALL REAR WHEEL RH
Torque: 140 N.m (1428 kgf.cm, 103 ft.lbf)