Reassembly

AIR CONDITIONING: AIR CONDITIONING UNIT (for Rear Side): REASSEMBLY

REASSEMBLY

1. INSTALL EVAPORATOR ASSEMBLY

(a) Install the evaporator.

(b) Install the rear cooling unit case (lower) with the 10 screws.

(d) Install the 2 brackets with the 6 screws.
2. INSTALL TUBE AND ACCESSORY ASSEMBLY

(a) Sufficiently apply compressor oil to 4 new O-rings and the fitting surface of the hose joint.
Compressor oil:
ND-OIL 8 or equivalent
(b) Install the 2 O-rings to the cooler evaporator.
(c) Install the 2 O-rings to the tube and accessory.
(d) Install the cooler expansion valve and tube and accessory to the evaporator.
(e) Using a 4 mm hexagon wrench, install the 2 hexagon bolts.
Torque: 3.5 Nm (35 kgf-cm, 30 in-lbf)
(f) Install the plate with the 3 screws.

(g) Install the new packing and butyl tape.
3. INSTALL WIRING AIR CONDITIONING HARNESS
(a) Install the harness, as shown in the illustration.

4. INSTALL DRAIN HOSE
(a) Install the drain hose, as shown in the illustration.

5. INSTALL BLOWER WITH FAN MOTOR
(a) Install the motor with the 3 screws.
(b) Connect the connector.

6. INSTALL AIR DUCT
(a) Install the duct with the 2 screws.

7. INSTALL SMOKE SENSOR
(a) Install the sensor with the screw.
(b) Connect the connector.

8. INSTALL MODE DAMPER SERVO ASSEMBLY
(a) Install the motor with the 3 screws.
(b) Connect the connector.

9. INSTALL DAMPER SERVO ASSEMBLY RH
(a) Install the motor with the 2 screws.
(b) Connect the connector.

10. INSTALL DAMPER SERVO ASSEMBLY
(a) Install the motor with the 3 screws.
(b) Connect the connector.

11. INSTALL DAMPER SERVO ASSEMBLY LH
(a) Install the motor with the 2 screws.
(b) Connect the connector.

12. INSTALL AIR REFINER ELEMENT
(a) Install the element, as shown in the illustration.

13. INSTALL AIR DUCT LH
(a) Install the duct with the 2 screws.

14. INSTALL AIR DUCT RH
(a) Install the duct with the 2 screws.