Installation

1UR-FSE FUEL: FUEL PRESSURE REGULATOR: INSTALLATION

INSTALLATION

1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
(a) Apply a light coat of gasoline to a new gasket, and install it to the fuel tank.






(b) Connect the fuel hose, and set the fuel suction with pump and gauge.
- Be careful not to bend the arm of the fuel sender gauge.
- When connecting the fuel hose, do not forcibly pull the hose.





(c) Install the set plate with the 8 bolts.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
HINT: Align the protrusion of the set plate with the cutout of the fuel suction pump and gauge.

(d) Install the fuel main tube and fuel return tube with the 2 tube joint clips.





NOTICE:





- Check that there are no scratches or foreign objects on the connecting parts.
- Check that the fuel tube joint is inserted securely.
- Check that the tube joint clips are on the collars of the fuel tube joints.
- After installing the tube joint clips, check that the fuel tube joints have not been pulled off.





(e) Connect the connector to the fuel suction with pump and gauge tube assembly.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. INSTALL COWL TOP VENTILATOR LOUVER RH Installation

4. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

5. CHECK FOR FUEL LEAKS Testing and Inspection

6. INSTALL REAR FLOOR NO. 2 SERVICE HOLE COVER
(a) Install the service hole cover with new butyl tape.
7. INSTALL REAR SEAT ASSEMBLY LH (for Power Seat)
(a) Install the rear seat assembly LH Installation.
8. INSTALL REAR SEAT ASSEMBLY LH (for Ottoman)
(a) Install the rear seat assembly LH Installation.
9. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)
(a) Install the rear seat cushion assembly Installation.