Removal

2GR-FE ENGINE MECHANICAL: ENGINE FRONT OIL SEAL:

REMOVAL

1. REMOVE FRONT WHEEL RH
2. REMOVE FRONT FENDER APRON SEAL RH
3. REMOVE COOL AIR INTAKE DUCT SEAL Removal
4. REMOVE ENGINE ROOM SIDE COVER LH Removal
5. REMOVE ENGINE ROOM SIDE COVER RH Removal
6. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
7. REMOVE V-RIBBED BELT Removal
8. REMOVE CRANKSHAFT PULLEY





(a) Using SST, loosen the crankshaft pulley bolt.
SST: 09213-70011
09213-70020
SST: 09330-00021





(b) Using SST, remove the crankshaft pulley bolt and crankshaft pulley.
SST: 09950-50013
09951-05010
09952-05010
09953-05020
09954-05021
9. REMOVE TIMING CHAIN CASE OIL SEAL
(a) Using a knife, cut off the oil seal lip.





(b) Using a screwdriver, pry out the oil seal.
NOTE:
After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.
HINT: Tape the screwdriver tip before use.