Installation

BRAKE CONTROL: REAR SPEED SENSOR: INSTALLATION

INSTALLATION
NOTE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.
HINT:
- The procedures listed below are for the RH side.
- Other than areas where instructions are provided, use the same procedures for the LH side and RH side.

1. INSTALL REAR SPEED SENSOR RH





(a) Install the sensor with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
- The rear speed sensor is easily damaged. When installing the rear speed sensor to the rear axle hub RH, do not use excessive force to rotate and install it.
- Prevent foreign matter from attaching to the sensor tip.
NOTE:
Prevent foreign matter from attaching to the sensor tip.

2. INSTALL SKID CONTROL SENSOR WIRE





(a) Connect the connector (labeled A) to the rear speed sensor.
(b) Install the sensor clamp (labeled B) with the bolt (labeled C).
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTE:
Do not twist the sensor wire when installing the clamps.

(c) for RH:
Connect the pad wear indicator connector (labeled D).





(d) Install the sensor clamp (labeled E) with the nut (labeled F).
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
NOTE:
Do not twist the sensor wire when installing the clamps.

(e) Except for RH side of models with coil spring type suspension:
(1) Install the sensor clamp (labeled G) with the nut (labeled H).
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
(2) Connect the rear height control sensor connector (labeled I).





(f) Insert the connector and grommet to the inside of the vehicle through the hole in the wheel house.





(g) Connect the rear speed sensor wire connector.
3. INSTALL REAR WHEEL
Torque: 140 Nm (1428 kgf-cm, 103 ft-lbf)
4. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH Installation
5. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH Installation
6. INSTALL REAR FLOOR FINISH PLATE Installation
7. INSTALL LUGGAGE COMPARTMENT TRIM COVER FRONT Installation
8. INSTALL COOLER COVER NO.1 (W/ Rear Cooler) Installation
9. INSTALL LUGGAGE COMPARTMENT NO. 2 TRIM HOOK (W/O Rear Cooler) Installation
10. INSTALL LUGGAGE COMPARTMENT NO. 1 LIGHT ASSEMBLY Installation
11. INSTALL DECK TRIM SIDE BOARD LH Installation
12. INSTALL DECK TRIM SIDE BOARD RH Installation
13. INSTALL ROPE HOOK ASSEMBLY Installation
14. INSTALL ROPE HOOK Installation
15. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation
16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
17. INSTALL COWL TOP VENTILATOR LOUVER RH Installation
18. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

19. CHECK SPEED SENSOR SIGNAL
(a) Check the speed sensor signal Test Mode Procedure.