Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Front Passenger Side): INSTALLATION

1. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the airbag connector to the front passenger side knee airbag assembly.





NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(d) Push in the lock to install the airbag connector.

(e) Temporarily install the front passenger side knee airbag assembly with the claw.





(f) Install the front passenger side knee airbag assembly with the 3 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

NOTICE:
Confirm that the front passenger side knee airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

3. INSTALL INSTRUMENT SIDE PANEL RH Installation

4. INSTALL FRONT DOOR OPENING TRIM COVER RH

HINT
Use the same procedure for the RH side and LH side Installation.

5. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

HINT
Use the same procedure for the RH side and LH side Installation.

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check Reading and Clearing Diagnostic Trouble Codes.

8. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.