Installation

PARKING BRAKE: PARKING BRAKE CABLE: INSTALLATION

1. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Install the parking brake cable clamp to the No. 3 parking brake cable assembly.





(b) Install the No. 3 parking brake cable assembly with 3 bolts (A), bolt (B) and nut (C), and engage each claw.

Bolt (A) - Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)

Bolt (B) and Nut (C) - Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)





(c) Install the No. 3 parking brake cable assembly to the backing plate with the 2 bolts.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)





(d) Using a brass bar and a hammer, install the clip to the No. 3 parking brake cable assembly.





2. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY Reassembly

3. INSTALL PARKING BRAKE SHOE ADJUSTING SCREW SET Reassembly

4. INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY Reassembly

5. INSTALL PARKING BRAKE SHOE STRUT Reassembly

6. INSTALL PARKING BRAKE SHOE RETURN TENSION NO. 1 SPRING Reassembly

7. CHECK PARKING BRAKE INSTALLATION Reassembly

8. INSTALL REAR DISC Reassembly

9. ADJUST PARKING BRAKE SHOE CLEARANCE Adjustments

10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Reassembly

11. INSTALL REAR WHEEL

12. INSTALL EXHAUST CENTER PIPE ASSEMBLY Installation

13. INSTALL EXHAUST TAIL PIPE ASSEMBLY Installation

14. INSTALL NO. 4 PARKING BRAKE CABLE ASSEMBLY

(a) Install the No. 4 parking brake cable assembly to the parking brake equalizer.





(b) Slide the rubber boot back as shown in the illustration.





15. CONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY

(a) Connect the No. 2 parking brake cable assembly to the parking brake equalizer.





16. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Connect the No. 3 parking brake cable assembly to the parking brake equalizer.





17. INSTALL CROSS MEMBER FLOOR NO. 4 REINFORCEMENT SUB-ASSEMBLY

(a) Install the cross member floor No. 4 reinforcement sub-assembly with the 8 bolts.

Torque : 19 Nm (194 kgf-cm, 14 ft-lbf)





18. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY Reassembly

19. INSTALL PARKING BRAKE PEDAL ASSEMBLY

HINT
Refer to the procedures up to "INSTALL PARKING BRAKE PEDAL". Installation

20. INSPECT FOR EXHAUST GAS LEAK Installation