Installation

2GR-FE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL TIMING CHAIN CASE OIL SEAL

(a) Apply MP grease to a new oil seal lip.





(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

SST : 09316-60011

09316-00011

Oil seal tap in depth:

0 to 1 mm (0 to 0.039 in.)

NOTICE:
* Keep the lip free of foreign matter.
* Do not tap the oil seal at an angle.

2. INSTALL CRANKSHAFT PULLEY

(a) Align the pulley set key with the key groove of the pulley, and slide on the pulley.

(b) Using SST, install the pulley bolt.





SST : 09213-70011

09213-70020

SST : 09330-00021

Torque : 250 Nm (2550 kgf-cm, 184 ft-lbf)

3. INSTALL V-RIBBED BELT Installation

4. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

5. INSTALL ENGINE ROOM SIDE COVER LH Installation

6. INSTALL ENGINE ROOM SIDE COVER RH Installation

7. INSTALL COOL AIR INTAKE DUCT SEAL Installation

8. INSTALL FRONT FENDER APRON SEAL RH

9. INSTALL FRONT WHEEL RH

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)