Diesel Data: Automotive Repair
Home >> Lexus >> 2012 >> ES 350 V6-3.5L (2GR-FE) >> Repair and Diagnosis >> Restraints and Safety Systems >> Seat Belt Systems >> Seat Belt >> Service and Repair >> Removal and Replacement >> Rear Seat Outer Belt Assembly >> Installation

Installation





SEAT BELT: REAR SEAT OUTER BELT ASSEMBLY: INSTALLATION

1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY

(a) Check the degree of tilt when the ELR begins to lock.





(1) Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the belt.

NOTICE:
Do not disassemble the retractor.

(b) Temporarily install the rear seat 3 point type belt assembly with the 2 bolts.





(c) Fully tighten the rear side bolt first, then the front side bolt to install the rear seat 3 point type belt assembly.

for Front bolt - Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

for Rear bolt - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

(d) Connect the pretensioner connector and lock the locking button as shown in the illustration.





2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade) Installation

3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade) Installation

4. INSTALL CENTER STOP LIGHT SET (w/o Rear Sunshade) Installation

5. INSTALL REAR SEAT SHOULDER BELT HOLE COVER Installation

6. CONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH Installation

7. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH Installation

8. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH Installation

9. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH Installation

10. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH Installation

11. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY LH Installation

12. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY RH

HINT
Use the same procedure for the RH side and LH side.

13. INSTALL REAR DOOR SCUFF PLATE LH Installation

14. INSTALL REAR DOOR SCUFF PLATE RH Installation

15. INSTALL REAR SEATBACK ASSEMBLY Installation

16. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY

17. INSTALL REAR SEAT HEADREST ASSEMBLY

18. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

20. PERFORM INITIALIZATION

NOTICE:
Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.

21. INSPECT SRS WARNING LIGHT

Diagnosis System
Diesel-Data.com