Installation

SUSPENSION: REAR SHOCK ABSORBER: INSTALLATION

1. INSTALL REAR SHOCK ABSORBER WITH COIL SPRING

(a) Install the rear shock absorber with coil spring to the rear axle carrier assembly and insert the 2 bolts from the rear of the vehicle.

(b) Slowly jack up the vehicle using a wooden block and install the rear shock absorber with coil spring (upper side) to the vehicle.





(c) Install the 3 nuts to the upper side of the rear shock absorber with coil spring.





Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)

(d) Install the 2 nuts and 2 bolts to the lower side of the rear shock absorber with coil spring.





Torque : 180 Nm (1,840 kgf-cm, 133 ft-lbf)

NOTICE:
When installing the nuts, keep the bolts from rotating.

(e) Fully tighten the lock nut.





Torque : 55 Nm (561 kgf-cm, 41 ft-lbf)

2. CONNECT REAR SPEED SENSOR

(a) Install the rear brake flexible hose and rear speed sensor wire harness with the 2 bolts.





Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf) (bolt A)

Torque : 19 Nm (194 kgf-cm, 14 ft-lbf) (bolt B)

3. INSTALL REAR STABILIZER LINK ASSEMBLY LH

(a) Install the rear stabilizer link assembly LH to the rear shock absorber with the nut.





Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)

HINT
If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.

4. INSTALL REAR SUSPENSION SUPPORT NO. 1 COVER

(a) Engage the 4 claws and install the rear suspension support No. 1 cover.





5. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH Installation

6. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade) Installation

7. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade) Installation

8. INSTALL REAR SEAT SHOULDER BELT HOLE COVER Installation

9. INSTALL REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH Installation

10. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH Installation

11. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH Installation

12. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH Installation

13. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH Installation

14. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY LH Installation

15. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY RH Installation

16. INSTALL REAR DOOR SCUFF PLATE LH Installation

17. INSTALL REAR DOOR SCUFF PLATE RH Installation

18. INSTALL REAR SEATBACK ASSEMBLY Installation

19. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY

20. INSTALL REAR SEAT HEADREST ASSEMBLY

21. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

22. INSTALL REAR WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

23. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

24. PERFORM INITIALIZATION

NOTICE:
Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.

25. CHECK ABS SPEED SENSOR SIGNAL

Test Mode Procedure

26. INSPECT SRS WARNING LIGHT

Diagnosis System

27. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Rear Wheel Alignment