Front Suspension

FRONT SHOCK ABSORBER AND COIL SPRING REMOVAL/INSTALLATION

Caution: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor wiring harness connector (axle side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.

1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.





3. Inspect the total wheel alignment if necessary.

Shock Absorber and Coil Spring Removal Note





1. Loosen the front lower arm inner bolt.
2. Separate the shock absorber from the wheel hub, steering knuckle component by tapping the upper part of the steering knuckle with a hammer.

Piston Rod Nut Removal Note

Warning: Before removing the piston rod nut, secure the shock absorber and coil spring in the SSTs. Otherwise, the coil spring could fly off under tremendous pressure and cause serious Injury or death, or damage to vehicle parts.





1. Install the shock absorber and coil spring to the SSTs using a piece of cloth in order to prevent the coil spring from being scratched.
2. Compress the coil spring using the SSTs and remove the piston rod nut.