Rear

REAR BRAKE (DISC) REMOVAL/INSTALLATION
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.





3. After installation, pump the brake pedal a few times and inspect the following:
- Parking brake lever stroke
- Brake drag

Disc Pad Removal Note
1. Remove the disc pad (outer side) from the mounting support.





2. Pull the disc pad (inner side) in the direction of the arrow to remove it from the caliper as shown in the figure.

Disc Pad Installation Note
1. Install the disc pad (outer side) to the mounting support.
2. Clean the exposed area of the piston.





3. Slowly rotate the piston clockwise while firmly pushing it to the caliper body using the SST and push the piston completely into the caliper body.

Warning: If the SST comes off the piston, it may cause other parts to crush against your hand causing injury. Be careful that the SST remains firmly connected to the piston when you push the piston Into the caliper body.





4. Align the disc pad (inner side) spring into the piston groove, and insert it in the direction of the arrow.
5. Install the disc pad (inner side) to the caliper.