Suspension: Service and Repair

1. Remove service lid trim from interior of vehicle, then raise and support vehicle.
2. Remove rear crossmember under cover panel, then remove center exhaust pipe.

Fig. 13 Rear Suspension Assembly:

3. Remove propeller shaft assembly, Fig. 13. Scribe marks on differential companion flange and flange yoke for installation reference, then separate differential carrier and propeller shaft. Suspend propeller shaft from vehicle body with wire ensuring there are no sharp bends in shaft assembly.
4. Remove brake caliper and brake assembly.
5. Remove parking brake cable.
6. On models with drum brakes, remove brake hose connection.
7. Remove upper arm bracket, then shock absorber cap and mounting nuts.
8. On models with ABS, remove speed sensor electrical connection.
9. Remove trailing arm grommet and mounting bolt.
10. Support differential case with suitable jack stand, then remove crossmember mounting nuts.
11. Reverse procedure to install, noting the following:
a. Bleed brake system as outlined under Brakes.
b. Inspect rear wheel alignment as outlined under Steering and Suspension.