Drum-In-Disc Brake
REMOVAL
Removal Service Point
Rear Brake Assembly Removal
Remove the rear brake assembly and support it with wire or similar
Shoe Hold-down Cup Removal
Extend the shoe and lining assembly, and remove the shoe hold-down cup
INSTALLATION
Installation Service Points
>A< Adjuster Installation
Install the adjuster so that the shoe adjusting bolt of left hand wheel is attached towards the front of the vehicle, and the shoe adjusting bolt of right hand wheel is towards the rear of the vehicle
>B< Shoe-to-anchor Spring Installation
The load on the respective shoe-to-anchor springs is different, so the spring in the figure has been painted
NOTE: The figure shows the left wheel, for the right wheel, the position is symmetrical.