Headlamp Bulb: Service and Repair

BULB REPLACEMENT




Headlight Bulb
1. Disconnect the battery.
2. Disconnect the connector.
3. Remove the socket cover.

CAUTION: Do not touch the surface of the bulb with hands or dirty gloves as the bulb may pop after a short time. If the surface does become dirty, clean it with alcohol or thinner, and let it dry thoroughly before installing.

4. Unhook the spring securing the bulb, and then remove the bulb.

CAUTION: Do not touch the surface of the bulb with hands or dirty gloves as the bulb may pop after a short time. If the surface does become dirty, clean it with alcohol or thinner, and let it dry thoroughly before installing.

5. Install the spring and sealing cover securely after the bulb replacement, or the lens will be out of focus, or water will get inside the light unit.




Position Light Bulb
1. Screw out the position light socket.
2. Disconnect the connector.

CAUTION:
- As a principal, the position light can be removed as individual part. If not, remove the position light from the headlight and position light assembly, and then remove the position light from the headlight Then replace the bulb.
- Do not touch the bulb surface bare-handed or with dirty gloves. If dirt is attached on surface of the bulb, immediately use alcohol or thinner to remove dirt, and install the bulb after well dried.