W6MAA
REMOVAL AND INSTALLATION
WARNING:
1 When removing and installing the skim cable & select cable assembly and the shift over assembly, be careful not to hit it against the SRS-ECU.
2 Never disassemble the shift level assembly (except the distance piece and bushing). (Non-provided part)
3 Do not apply mineral oil on the moving part of the shift level assembly. Using mineral oil may damage the resin part.
REMOVAL SERVICE POINTS
<> SELECT CABLE CONNECTION (TRANSAXLE SIDE) REMOVAL
Set the clip of the select cable as shown in figure 1 and 2, and disconnect the select cable.
<> GEAR SHIFT LINK CLIP REMOVAL
Push up the claws of the gearshift link clip using a screwdriver, etc., and then remove the gearshift link clip from the bracket together with the cables.
INSTALLATION SERVICE POINTS
>>A<< GEAR SHIFT LINK CLIP INSTALLATION
CAUTION: Insert thoroughly the gearshift link clip, shift cable and select cable until they click in place.
1. After installing the new gearshift link clip to the cable bracket of the transaxle, install the shift cable and select cable to the cable bracket.
NOTE: The clip is reversible.
2. Move the shift lever to all positions and check that the operation is smooth.
>>B<< SELECT CABLE CONNECTION (TRANSAXLE SIDE) INSTALLATION
CAUTION: Check that the clip is securely installed.
1. Install the clip of the select cable as shown in the illustration.
2. Move the shift lever to all positions and check that the operation is smooth.
>>C<< SELECT CABLE CONNECTION (SHIFT LEVER SIDE) INSTALLATION
1. Move the shift lever until it contacts the 5-speed or 6-speed stopper to stabilize the shift cable at the shift lever.
2. Release the shift lever, and install the select cable (at the shift lever side) to the select lever while the lever is at the neutral position.
3. Check that the shift cable (shift lever side) and the select cable (shift lever side) are installed securely, and move the shift lever to all shift positions.
4. If the shift lever cannot be moved to the shift positions, adjustment the select cable.
SELECT CABLE (CABIN SIDE) ADJUSTMENT
1. Place the shift lever to the neutral position .
2. Remove the front floor console.
3. Remove the select cable from the select lever.
4. Move the shift lever until it hits the stopper at the 6th gear side.
5. Release the shift lever to place it to the neutral position.
6. Move the lock clip of the select cable towards the arrowed direction in the figure, and pull the fixing clip.
7. Install the select cable to the select lever, taking care not to move the shift lever from the neutral position.
8. Pulling the select cable slightly towards the cabin side, press in the fixing clip of the select cable. Then, return the lock clip back to the original state.
9. Move the shift lever to all shift positions.
NOTE: If the shift lever cannot be moved to each position or is difficult to move, repeat from step 3 to step 9.
10. Install the front floor console.