MIVEC Engine
Cylinder BlockCylinder bore 95.0 mm (3.74 in)
Crankshaft end play
Standard value 0.05 - 0.25 mm (0.002 - 0.009 in)
Limit 0.3 mm (0.01 in)
Crankshaft journal outside diameter
Standard value 64 mm (2.520 in)
Crankshaft pin outside diameter
Standard value 55 mm (2.165 in)
Crankshaft journal oil clearance
No.1, 4
Standard value 0.02 - 0.03 mm (0.0008 - 0.0012 in)
Limit 0.1 mm (0.003 in)
No.2, 3
Standard value 0.03 - 0.04 mm (0.0008 - 0.0015 in)
Limit 0.1 mm (0.003 in)
Piston to cylinder clearance
Standard value 0.02 - 0.04 mm (0.0012 - 0.0019 in)
Cylinder block flatness of gasket surface
Standard value 0.05 mm (0.02 in)
Limit 0.1 mm (0.003 in)
Cylinder block grinding limit of gasket surface total resurfacing depth of both cylinder head and cylinder block
Limit 0.2 mm (0.008 in)
Cylinder block overall height [upper plane of cylinder block from crankshaft center]
Standard value 284 mm (11.2 in)
Cylindricity
Standard value 0.01 mm (0.0003 in)
Bearing Cap
Tighten the bearing cap bolts to specified torque in the sequence shown in the illustration.
Tightening torque 74 ± 4 Nm (54 ± 3 ft-lb)
Connecting rod big end side clearance
Standard value 0.10 - 0.25 mm (0.004 - 0.009 in)
Limit 0.4 mm (0.02 in)
Connecting rod cap nut 27 ± 2 Nm (20 ± 1 ft-lb) + 90° to 94°
Piston outside diameter
Standard value 95.0 mm (3.74 in)
Piston ring to ring groove clearance mm (in)
No.1
Standard value 0.03 - 0.07 (0.0012 - 0.0027)
Limit 0.1 (0.003)
No.2
Standard value 0.02 - 0.06 (0.0008 - 0.0023)
Limit 0.1 (0.003)
Piston ring end gap mm (in)
No.1
Standard value 0.25 - 0.40 (0.010 - 0.016)
Limit 0.8 (0.03)
No.2
Standard value 0.35 - 0.50 (0.014 - 0.019)
Limit 0.8 (0.03)
Oil ring side rail
Standard value 0.10 - 0.35 (0.004 - 0.014)
Limit 1.0 (0.03)
Piston pin outside diameter mm (in)
Standard value 22.0 (0.87)
Idler pulley bolt 44 ± 5 Nm (33 ± 4 ft-lb)