MIVEC

REMOVAL AND INSTALLATION [MIVEC]

CAUTION:
- When the throttle body assembly replacement is performed, use scan tool MB991958 to initialize the learning value (Refer to General, Initialization Procedure for Learning Value in MFI Engine).
- Do not loosen the fixing screws for the resin cover of throttle body assembly. If the screws are loosened, the sensor incorporated in the resin cover becomes misaligned and the throttle body can not work normally.

Pre-removal Operation And Post-installation Operation:

Removal Steps 1-4:

INSTALLATION SERVICE POINTS

]]A[[THROTTLE BODY GASKET INSTALLATION

CAUTION: Poor idling etc. may result if the throttle body gasket is installed incorrectly.




Install the gasket with its protrusion in the direction shown.

]]B[[ INITIALIZATION PROCEDURE
Turn the ignition switch on, then off, and keep it off for at least 10 seconds.