Body Emblem: Service and Repair

MARK

REMOVAL AND INSTALLATION

Removal Steps 1-8:

INSTALLATION SERVICE POINT

]]A[[ MARK INSTALLATION

2. Rear three-diamond mark







3. MITSUBISHI mark [Vehicles for USA and Canada]







4. LANCER mark [Vehicles for Puerto Rico]







5. LANCER mark [Vehicles for USA and Canada]







6. GT mark [Vehicles for Puerto Rico]







7. RALLIART mark [RALLIART]







8. RALLIART mark [Vehicles for Puerto Rico]







1. Installation position
Attach each mark to the position shown in the illustration.

2. Installation procedure
1. Use 3M(TM) AAD Part number 8906 or equivalent to clean the mark installation surfaces on the body.

CAUTION: When attaching the marks, the ambient temperature should be 20 - 38° C (68 - 100° F) and the air should be completely free of dust. If the ambient temperature is lower than 20° C (60° F), the marks and the places on the vehicle body where the marks are to be attached should be heated to 20 - 30° C (68 - 86° F).

2. Peel off the protection sheet on the back of the marks to affix it in position.