Assembly

ASSEMBLY





1. Install D-ring and oil seal on piston.
- Take care with the direction of the oil seal.
- Apply ATF to both parts.





2. Stand transmission case.
3. Install piston assembly on transmission case while turning it slowly.
- Apply ATF to inner surface of transmission case.





4. Install return springs and spring retainer on piston.





5. Install snap ring while compressing return springs.
- Set Tool directly above return springs.





6. Install drive plates, driven plates, retaining plates and dished plates.
- Do not align the projections on the two dished plates.
- Make sure to put the plates in the correct order and direction.





7. Install snap ring.





8. Measure clearance between retaining plate and snap ring. If not within allowable limit, select proper retaining plate (front side).

Specified clearance:
Standard: 1.4 - 1.8 mm (0.055 - 0.011 in)
Allowable limit: 2.8 mm (0.110 in)
Retaining plate: Refer to SDS.





9. Check operation of low & reverse brake.
Refer to "DISASSEMBLY" in "Low & Reverse Brake".