AWD Mode Indicator Lamp (AWD-V)

AWD MODE INDICATOR LAMP (AWD-V)





Component Function Check
1.AWD MODE INDICATOR LAMP OPERATION CHECK
1. Turn the ignition switch ON.
2. Set AWD mode switch to "AWD-V".
3. Check that AWD mode indicator lamp (AWD-V) turns on.
Is the inspection result normal?
YES - INSPECTION END
NO - Proceed to SEE Diagnosis Procedure.




Diagnosis Procedure
1.CHECK AWD WARNING LAMP
1. Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.
2. Stop the vehicle.
Does AWD warning lamp turn ON?
YES - Proceed to AWD Warning Lamp.
NO - GO TO 2.
2.CHECK AWD MODE SWITCH
Perform the trouble diagnosis for AWD mode switch. P1813.
Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace the error-detected parts.
3.CHECK AWD MODE INDICATOR LAMP SIGNAL
With CONSULT-III
1. Start the engine.

CAUTION:
Never drive the vehicle.
2. Change AWD mode switch to "AWD-V" from "2WD".
3. Check "INDICATOR" in "DATA MONITOR" for "ALL MODE AWD/4WD".
Does the item on "DATA MONITOR" indicate "AWD-V"?
YES - GO TO 4.
NO - Replace AWD control module. Removal And Installation.
4.CHECK COMBINATION METER POWER SUPPLY CIRCUIT
Perform the trouble diagnosis for combination meter power supply circuit. Power Supply And Ground Circuit, "COMBINATION
METER : Diagnosis Procedure".
Is the inspection result normal?
YES - INSPECTION END
NO - Repair or replace the error-detected parts.